Model No:DSO-10100S
Voltage Difference (V) between cursors; Time Difference (T) between cursors; Reciprocal of AT(1/0) Voltage & Time of waveform point it is allowed to display cursor during automatic measurement
Peak value, amplitude, the maximum value, the minimum value, top value, bottom value, middle value, average value, root-m frequency, cycle Rise Time, Descend Time, positive pulse width negative pulse width, positive duty cycle, negative duty cycle
+, x,
Specfication:-
PDC-10000 Series
Model Band width
DSO-10100S
Pulse with Trigger Vertical Sensitivity 50mV/div-500V/div
Horizontal Time base Range
Trigger Sensitivity
Trigger level scope
Trigger Mode Trigger Edge Coupling
Maximum Test Voltage leasurement
Cursor
Automatic measurement
Mathematical operatioin
100MHz
Real-time 1GS/s
50S/div lOnS/div
1V
Internal ± 5 div away from screen center EXT ± 3V EXT / 5* ± 15V
Single, Normal, Auto Rising Flank/Falling Flank AC/DC
40V(1xprobe), 400V(10xprobe)
Manual mode
Tracing mode
Voltage Difference (V) between cursors; Time Difference (T) between cursors; Reciprocal of AT(1/0) Voltage & Time of waveform point it is allowed to display cursor during automatic measurement
Peak value, amplitude, the maximum value, the minimum value, top value, bottom value, middle value, average value, root-m frequency, cycle Rise Time, Descend Time, positive pulse width negative pulse width, positive duty cycle, negative duty cycle
+, x,
Stored waveform built-in 1GB storage space, can store up to 1000 screen capture pictures + 1000 groups of waveform data 240Kbit LCD 7 INCH 800+400
Lissajou's figure
Power Power Voltage Power Consumption
Fuse
Dimension
Accessories Trigger Frequency Meter* Reading resolution 6-bit
Phase location difference
±3 degrees
100-240VACRMS, 45-440Hz, CAT II To be less than 30VA F1, 6AL, 250V; Fuses are on power board in the unit Width 310mm Height 145mm Depth 70mm 100M Probe *2, USB Charger, User Manual
Trigger Sensitivity <30Vrms
Features
Built in DDS Function Signal Generator 14 standard signals (@2.5VPP). including sine wave, square wave, triangle wave, sawtooth, anti sawtooth, ladder wave, half wave rectification, full wave rectification, exponential wave, logarithmic wave, pair index, open square wave, multi audio, sink pulse wave, as well as a cut-off output function that can customize the output signal freely. in which the sine wave frequency can reach 10MHz at most and other standard signals can reach 2MHz. cuff-off frequency can reach 2MHz. The wave output device can reach 1 MHz at most an the frequency resolution of all signals can reach 1Hz (Step). It is not the half frequency step mode of half frequency division produced by other handheld devices.
(Typical) Precisitiorth51ppm(+word)
