Model No:FM-2409
A tilter press contains a set of plates designed to provide a series of chambers or compartments in which solids may collect. The plates are covered with a filter medium such as canvas cloth. Slurry is admitted to each compartment under pressure; liquor passes through the canvas cloth and out a discharge pipe, leaving a wet cake of solids behind. Plates and frames sit vertically in a metal rack, with cloth covering the face of each plate, and are squeezed tightly together by, screw. Slurry enters at one end of the assembly of plates and frame. It passes through a channel running lengthwise through one corner of assembly.
The set up consists of 7 plates and 6 frames. Frames are covered with filter cloth. Feed is fed b gear pump at the top and filtrate collected at the bottom from each plate by operating the cock. After removing Cake, washing and cleaning can be done by water provided by overhead tank. Inlet & outlet pressures are measured by pressure gauges. Rate of filtrate removals is measure by calibrated tank provided.
1. Frame : 6 Nos.
2. Plates : 7 Nos( Size 200 mm x 200 mm.)
3. Material : Acrylic (MS/SS on request)
4. Filter Medium : Filter Cloth, Filtrate Collection Tray
5. Slurry Feed Tank : Material SS, Suitable size.
6. Slurry Tank Agitator : Material SS, Capacity 40 Ltrs.
7. SS Impeller : with SS Shaft coupled to FHP
8. Screw Jack Arrangement : For tightening & removing of frames
9. Slurry Feed Pump : Motor and Reduction Gear BI
10. Gear Pump : with FHP standard Make motor.
11. Piping System : GI and PVC
12. Pressure Measurement : Bourdon type pressure gauge
13. Overhead Water Tank : Material SS , Capacity 25 Ltrs
14. Control Panel : On / off , Mains Indicator & fuse etc
